Some comp oil pans came with a place to install an oil temp gauge. The location was near the drain plug. Stan == /// datsun-roadsters@autox.team.net mailing list
Mike has two places that he can be at. He is not always in. There is an outgoing message on each number that gives the alternate phone number option. == /// datsun-roadsters@autox.team.net mailing li
Your brake light switch is probably OK. There is/was a rubber pad on the brake pedal on a bracket that opened the switch when the pedal was in the up position. When the rubber thing falls out or get
Better be cautious about the comments. He, Lou, can produce dyno slips. They read in KW but that can be converted. I have been to the shop and there is a dyno next door that he uses. Some of the car
Kit mounts "L" series engine on original rubber mounts in original location. Tall windshield car will fit L20B and LZ22 blocks as well as L16/L18 without hood mods. Low windshield cars fit L-16 and L
Hi Matt, I have a new set of side and rear emblems for $240 and a new mirror for $60 and some used hubcaps that are priced based on condition. I also have some new hood letters. Stan == for my 66' 16
NGK stands for No Good Kind but they usually work. It used to be, a long time ago, that the ones from the auto supply were made in the US and the ones at the Datsun dealer were made in Japan. There s
I recently posted a message about Low Windshield availability for local pickup only. I have located a packing facility that will pack individual windshields suitable for shipping by UPS ground or FED
Can you recommend a manufacturing source for the gears that doesn't think that they would be "all that difficult" to fabricate? Also, can you recommend any design improvements to enhance performance
Hey Fergus, The od of the rubber is about .825" and it is about 3/16" thick. The id is an interference fit with the 8mm bolt so that it stays on when putting the mess together. The cup washer goes ov
The Nissan part number is 23300-P5111. I have a remanufactured short starter that I will sell for $93. No exchange required. Stan == /// datsun-roadsters@autox.team.net mailing list
Mark the list administrator sent the following. There is a paypal option in addition to a few others for donation. Stan \==/ any something computer Dollars At 09:11 AM 4/18/02 -0400, Greg Hare wrote
I have main bearings in standard, .010 and .020 but they are not cheap. I don't have any pistons but have seen them advertised on a well known net site that includes pricing. Stan == /// datsun-road
I have obtained several new low windshields. These are aftermarket ones that are US DOT approved and have the number on the glass. The construction is the laminated style with plastic between two lay