Hi Pat, I wish that you had told me first about the seam problems. I do remember you telling me about a few installation problems that you overcame. The flaps for the side bars were standard and can
I don't think that any of the tires had a 100% aspect ratio but maybe they did? I took an empirical approach and did my check the old fashioned way. I used a 5.60-14 tire and a tape measure. The tir
A year or two back someone posted a chaser die for the lower suspension threads for sale. Please contact me if you are still on the list and still have the die. Thanks, Stan Torrance, CA
If the bearings are good and the setup is correct then you can remove the flange, pry out the seal, replace the seal and assemble the flange. Torque the nut to get the same rotational resistance as
You don't want the guides because they are just slugs of material that need machining on the inside and the outside. Get a good machine shop to replace them. Stan Torrance, CA == for a
There is a roadster in Denver that is for sale. The owner is Steve Flint and he is in the UK. He worked for G-Force, the IRL race car builder, as a fabricator in Denver and purchased a car that had b
John Morton said that he was disqualified for rough driving in a race at Willow Springs, CA after he beat a 911 because the official said that there was no way that a Datsun could beat a 911 fairly.
Driver in position #9 (G. Van Bogart) owns, or did own, a 67.5 Datsun roadster too. I think that he was one of the charter members of the DROC in LA. Stan ==
I have the following new parts for sale until June 15. Quantities are 2000 4 Piece Clutch Kit Nissan comp pressure plate, Valeo disk, throwout bearing and pilot bushing. Will work better than origina