Perry,
Tap all of the holes for a standard NPT plug. Use plugs that tighten flush with
a hex key. All of those plugs should have been removed for a more thorough
cleaning.
Regards,
Harold
> On Sep 5, 2025, at 4:31â?¯PM, Perry Small via Healeys
> <healeys@autox.team.net> wrote:
>
> Listers. Any advice on this info request�
> Recently had a BJ8 engine block hot tanked and cleaned. Unfortunately,
> Machine shop drilled out all the small brass oil and water gallery plugs. Do
> you know of a source for those or info on the dimensions to fabricate them?
> End copy
>
> Perry
> Sent from my iPhone
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive/healeys
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/manifold@telus.net
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys
http://autox.team.net/archive/healeys
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|